Under-Vehicle Scanning Systems: Four Parameters and Three Siting Mistakes

2026.11.16

Short answer

An under-vehicle scanner does one job: showing what is attached to the underside of a vehicle. Selection comes down to four parameters — resolution, scan speed, ingress protection and integration with barriers and ANPR. Siting causes more failures than the hardware: a speed bump, a slope or strong backlight will ruin the image whatever camera you buy.

What it can and cannot see

A line-scan camera under the roadway captures the underside as the vehicle passes, and the system stitches the frames into one image for the operator to compare against a reference. It shows:

  • Attachments, strapping and signs of modification
  • Concealed packages, containers of liquid, tools
  • Damage, leaks and unusual welding

It does not see: cargo inside the vehicle (that is the X-ray scanner's job), or items that match the colour and texture of the underbody exactly.

Three forms

FormInstallationBest forLimitation
FixedCast into a channel, linked to the barrierCheckpoints, ports, campus gates, prisonsCivil works; the position is final
MobileCraned or towed into place with a portable barrierTemporary checkpoints, events, emergenciesNeeds flat hardstanding
PortableCarried by two people, deployed in minutesRoadside spot checksLower throughput, lighter protection

The four parameters that matter

Resolution. Decides how fine a scratch or cable you can see. Checkpoint grade is better than 0.5 mm; 1 mm is enough for a campus gate.

Scan speed. Must match how vehicles actually pass. A common specification is 5–15 km/h, and a wider range tolerates inconsistent driving.

Ingress protection. Buried equipment sits in water; IP68 is the baseline. In cold regions, freeze-thaw and de-icing salt matter too.

Integration. Whether it talks to ANPR, barriers, CCTV and the alarm platform decides whether it is a camera or a system.

Siting: three mistakes that ruin the image

Mounted on a speed bump. The vehicle bounces as it crosses, so the camera records motion blur. Put the bump three to five metres before the scan zone, not on it.

Mounted on a slope. The distance between underbody and camera changes, the scale distorts and the stitching misaligns. The scan zone must be level.

Facing strong backlight or standing water. Line-scan cameras are sensitive to light; low sun or reflected glare blows out the image. Add a hood or change the orientation.

What to check at acceptance

  • The same vehicle passes three times and all three images are complete, sharp and correctly stitched
  • Saloon cars, SUVs and trucks all image fully without cropping
  • Night and rain performance degrades only within an agreed margin
  • Barrier integration: time from scan complete to barrier open is within the specified limit
  • Image retention meets local requirements, commonly 30–90 days

FAQ

Can it replace a manual underbody check? Not entirely, but it removes most vehicles from the manual queue. High-security sites still retain random manual inspection.

Does it work in rain? The hardware is sealed, but standing water reflects light and droplets form a film on the lens. A canopy over the entry helps a great deal.

How wide should the scan zone be? Leave margin for the widest vehicle including mirrors; 3–4 m is typical. Too narrow and large vehicles are cropped.

Can it work alongside an X-ray scanner? Yes, they are complementary: the underbody system looks underneath, the X-ray looks inside the cargo. Ports and major checkpoints usually run both.

Related

Fixed vs mobile container scanning · Comparing the five detector types

Products: under-vehicle scanning system · FJ-PDS600 container scanner

Want advice for your own site? Tell us what you inspect, the daily volume and the site conditions — we will propose an approach before proposing a product.