Seafood X-ray foreign object detection: what it finds and what it misses
Seafood is one of the harder categories for foreign object detection. Product density varies from frozen blocks to loose shrimp, packaging often includes aluminium trays or metallised film, and the contaminant most buyers worry about — bone — sits close to the product in density. This page explains what an X-ray system can realistically detect in seafood, how to specify one, and where a metal detector still does a better or cheaper job.
What X-ray finds in seafood
An X-ray inspection system measures how much each pixel attenuates the beam, then compares that with the product baseline. Anything denser than the surrounding flesh shows as a darker region. In practice this means:
- Bone fragments — detectable down to roughly 0.5–1.0 mm depending on product thickness and whether the bone is calcified
- Shell and cartilage — usually detectable, but soft shell in a thin fillet is marginal
- Metal — wire, hooks, mesh fragments, and fragments from processing blades; typically the easiest category
- Glass and hard plastic — detectable if density differs enough from the product
- Stone and grit — detectable in most products
What it misses
Three limits matter when you buy:
- Soft materials with similar density — a piece of soft plastic or a rubber band inside a dense block can pass
- Very thin products — contrast is proportional to path length; a 5 mm fillet gives less signal than a 50 mm block
- Foil and metallised packaging — aluminium trays attenuate heavily and mask the product underneath. If your line uses foil trays, the system must be specified for it, or the inspection point moved upstream of packing
X-ray or metal detector for seafood?
Most seafood lines need both, but at different points:
- Metal detector — cheap, fast, catches ferrous and non-ferrous metal, including fragments inside foil-sealed packs. Cannot see bone, shell or glass
- X-ray — catches bone, shell, glass and stone as well as metal, but struggles with foil packaging and thin products
The usual configuration is a metal detector immediately after packing (including foil packs) and an X-ray system on bulk or unpacked product where bone and shell are the main risks.
How to specify a seafood X-ray system
Five parameters decide whether the system will work on your line:
- Tunnel size and belt width — sized to the largest pack or bulk crate, not the average
- X-ray power and detector resolution — thin fillets need higher resolution, not higher power
- Contaminant standard — specify the actual test pieces you will use at acceptance, in millimetres, per product
- Washdown rating — seafood lines are wet and salty; specify IP66 or better
- Reject mechanism — air blast, pusher or flap, matched to pack weight and line speed
Acceptance test that actually proves something
Run the test pieces through real product, not through an empty belt. A system that detects a 1.0 mm steel sphere on an empty belt may miss a 2.0 mm fragment inside a 40 mm frozen block. Write the product, the contaminant size and the pass/fail criterion into the purchase order.
Next step
If you are selecting a system for a seafood line, the practical starting point is the food X-ray inspection overview, then the comparison of X-ray and metal detection. Both pages explain the decision sequence rather than quoting a fixed specification.